Week 13

First PCB was failure because of many intermittent occurs within the board for unknown reasons. Several troubleshooting were done to find solution for the problems.
To avoid wasting amount of time, new UV board was used due to faster and simpler process required to finished the PCB. Also, with the new design, the connection of each components was simpler and separated to prevent any intermittent.

Next, the potentiometer was soldered and ready to be wired by using shrink tube to avoid messy connection or cut on the joints. The sensor holder was placed and positioned at the correct position in order to make it function and aligned. Finally, all mechanical structure and software are ready to be interfaced.