Week 7

Week 7 is the phase test week...
So, I managed to completed some part of proposal that is problem statement...
Problem statement is a short summary of the research problem....
This is the problem statement of KJT devices...
These are main reasons of why this project and research ....

1. Knee replacement, or knee arthroplasty, is a surgical procedure to replace the weight-bearing surfaces of the knee joint to relieve the pain and disability of osteoarthritis. Knee replacement surgery can be performed as a partial or a total knee replacement. In general, the surgery consists of replacing the diseased or damaged joint surfaces of the knee with metal and plastic components shaped to allow continued motion of the knee.

Components of Total Knee Arthroplasty

2. The anterior cruciate ligament (ACL) is a cruciate ligament which is one of the four major ligaments of the human knee. The ACL originates from deep within the notch of the distal femur. It is referred to as the cranial cruciate ligament. Athletes commonly tear the ACL when the tibia translates anterior to the femur in combination with an internal tibial rotation.

Figure: Anterior Cruciate Ligament (ACL) tear (Left), and Internal Tibial Rotation (Right)

3. Cartilage structures and functions can be damaged. Such damage can result from a variety of causes, such as a bad fall or traumatic sport-accident, previous knee injuries or wear and tear over time. Immobilization for long periods can also result in cartilage damage. Articular cartilage does not usually regenerate (the process of repair by formation of the same type of tissue) after injury or disease leading to loss of tissue and formation of a defect.

Autologous Chondrocyte Implantation (ACI) Procedure

    

Readmore...

Week 6

Based on what I have research on the internet, I found a video that shows on how the KJT device working...

Here is the video.... 

The guideline for proposal FYP Degree Sem1 has been uploaded on rps.bmi.edu.my...

These are the list of main focus on writing the proposal...

1. Abstract

2. Introduction

3. Problem Statement

4. Literature Review

5. Methodology

6. Objectives

7. Benefits/contributions

8. Planning

9. Budget

10. Conclusion

11. References

Readmore...

Week 5

Introduction of this project is main overview to indicate of main idea and proper methods to execute it.

The introduction also should be at a level that make it easy to understand for readers with a general science background...
Many researches on internet have been done to gathered all main informations...
This is the introduction of this project...

Introduction

• Orthopaedic surgeons nowadays always looking into ways to improve the results after knee surgery. 
• Knee Joint Therapy (KJT) Device was develop assist recovery following joint surgery or injuries of upper or lower extremities. 
• KJT is used to reduce the adverse effects of trauma or immobilization following surgery. 
• KJT units are motorized devices which gradually move the joint through a defined range of motion for an extended period of time without patient effort. 
• There are two basic design principles that characterize KJT devices: 
1) the anatomical design, or

2) the free linkage design

Readmore...